Good Graph
NEW!
Own an XP TechnoHUNT system? Is your warranty still in effect? Warranty about to run out? Make sure your system is covered after the original warranty is up by purchasing a service plan!
Call Toll Free: 1-877-890-9572
Copyright © 2010 Archery Interactive
All rights reserved
What is a good graph?
The graph shown above is an example of a “good graph.” Notice that all points on the graph between the 512 and 1536 marks (as shown by the red vertical lines) are kept above the 60 lumens mark (shown with the horizontal red line). You may have to raise the sensitivity with the appropriate slider in the sensor sensitivity setting on the “arrow tracker options” page.
- The graph needs to extend from approximately the 512 to 1536 pixel marks on the bottom of the screen.
- All points of the graph between the 512 and 1536 pixel marks should be at least 60 lumens or above. (If necessary, raise the sensor sensitivity with the appropriate slider on the “arrow tracker options” page.)
- There should be no single pixel down-spikes in the graph that drop more than ten (10) lumens.
No two sensors’ graphs will be exactly alike, but if you understand what makes a good graph, you will be able to get your individual sensor’s graph looking its best.
|
||||||
|
